AgamRobotics Docs
  • Welcome
  • Autopilots/Flight Controller
    • Agam Autopilot v6X-RT
      • Introduction
      • Technical Specification
      • Firmware
      • Pixhawk Autopilot Standard
      • Supported Hardware
      • Placement and Orientation
      • Baseboard Port
      • Agam Autopilot v6X-RT Wiring
      • In-Field Compass calibration
      • Companion computer setup
  • Power Modules
    • DPM01
    • PX4 Setup
Powered by GitBook
On this page
  1. Power Modules

DPM01

This is the standard Digital Power Module for Agam Autopilot v6X-RT.

DPM01 is a low profile design that comes with XT60 pre-soldered on both sides.

The power module is connected using the I2C protocol. It is designed for flight controllers based on the Pixhawk FMUv6X open standard like Agam Autopilot v6X-RT

Tech Spec:

Max input voltage: 36V

Rated current: 60A

Max current: 120A (<60S)

Outputs: 5V and 3A max

I2C interface for Voltage and current monitor

Supports up to 6S battery

Weight: 30g

PreviousPower ModulesNextPX4 Setup

Last updated 6 months ago